Over time, a well-used Tanker™ can pick up discoloration or rust. Denali's cleaning guide already gives a simple method that uses pantry ingredients. The care and storage notes below also appear on The Tanker's product page.
What You'll Need
- Water, adjusted to the level of discoloration
- Cream of tartar: 2 tablespoons for every half gallon of water
- White vinegar, for the valve and weight
- A non-abrasive scrubber
Loosen Residue in the Pot
Mix water with cream of tartar at the ratio above and bring it to a boil in the canner. Let it simmer so residue can loosen. When the film has lifted, empty the pot, rinse it thoroughly, and let it air dry. Denali's product care notes also say to wash with warm, soapy water and to avoid abrasive tools that can scratch the surface.
Clean the Valve and Weight
Use white vinegar and a scrubber on the valve and weight to remove rust or discoloration. Rinse those parts well and let them dry completely before you put the canner back together. A clean valve and a correctly seated weight matter for the next canning day, because the weight sits on the valve stem and a tight stem helps prevent leaks.
Dry and Store
After rinsing, air dry the canner before you reassemble it. Denali's product guide recommends storing the canner with the lid off so odors and moisture do not collect inside. Check the gasket when you put the canner away or when you get it out for the next session, and replace it if it looks cracked, stiff, or stretched.
This routine keeps The Tanker looking better and ready for the next batch. It does not replace the safety and operations manual that ships with the canner.
Comments (0)
There are no comments for this article. Be the first one to leave a message!